OBSBOT Tiny SE Remote

Prepare the table computer

Complete these checks on the computer physically connected to the Tiny SE.

Camera connected by USBThe Tiny SE has power and Windows can see it. OBSBOT Center is openKeep it running for the entire game session. Camera preview worksConfirm the Tiny SE appears and responds inside OBSBOT Center.

Open OBSBOT Center download

Camera missing from OBSBOT Center

Reconnect the camera directly to the computer, avoiding an unpowered USB hub.
Close other camera-control utilities, then restart OBSBOT Center.
Try another USB port and confirm the camera appears in Windows Device Manager.

Match the OSC connection

Open OSC settings in OBSBOT Center, enable OSC, then enter the same protocol and port here.

Operating mode

Real camera Simulation

Protocol

UDP TCP

OSC host Center receive port Camera index

In OBSBOT Center, turn OSC on, select UDP Server, set Host to 127.0.0.1, and Receive Port to 16284. No send port is required.

Connection settings have not been tested.

Where do these values come from?

Center's OSC on/off control must be enabled; merely opening its OSC settings does not activate the server. The OSC host must match the address selected with Center's Host picker. Use 127.0.0.1 only when Center binds loopback; otherwise select this computer's Ethernet or Wi-Fi IPv4 address and enter it here. No send port is required. Start with camera index 0.

Confirm the camera responds

This test nudges the camera right, stops it, then returns it to center.

Clear the camera's movement area

The Tiny SE will move when the test starts.

Camera response has not been confirmed.

Create the player's remote link

The local link is useful for testing. Start a public link when the remote player is ready to join.

Local player link

Tailscale connection

Use the private route when the player can join your tailnet; it can connect peer to peer. Public Funnel works without a player install but adds a relay.

Get Tailscale

Checking Tailscale...

Tailscale HTTPS address Player link

Waiting for a player connection.

Use Cloudflare instead

Run this command in a second terminal, then paste the resulting HTTPS address above.

Player cannot connect

Send the complete Internet player link, including everything after ?token=.
Confirm the control server is open and Tailscale reports that the public link is running.
Open the Internet player link on your phone using cellular data to test outside the home network.
Never forward the OBSBOT OSC port through the router.

Ready check

Review the live checks before handing camera control to your player.

...Control serverBrowser is connected and authenticated as host.

...OBSBOT connectionConnection settings were saved and tested.

...Camera responsePhysical movement was confirmed by the host.

...Player linkA shareable player URL is ready.

...Player connectedThis may remain pending until game time.

...Emergency stopStop and host lock were tested.

Test emergency stop

This sends stop and locks player controls. Unlock them from the Host panel afterward.

OBSBOT Tiny SE Remote

PTZ

Presets

Modes

Host

Status

Host setup